PipeFit Pro: Pipe Calculatorv10.2.7

What changed

• New featureAdded support for different fittings on each end of a spool in Spool Cut calculations.
• LocalizationFixed Imperial/Metric toggle to convert existing values rather than re-reading them.
• LocalizationCorrected slope reporting for Deg ↔ mm/m in Metric units.
• UXRelabeled Rolling Offset diagram hypotenuse from 'Travel' to 'True Offset'.
• ContentRestricted Short Radius take-out values to ASME B16.28 standard sizes (NPS 1–24).
• ContentAdded source labeling for take-out values to distinguish between ASME tabulated and calculated values.
• UXImproved drawing clarity for Miter Cut, Segment Elbow, and Weld Prep angle marks.
• UXEnhanced readability of bolt numbers on flange patterns for all pressure classes.
• New featureExpanded the Saved list to display all calculator types instead of just offsets.
• UXUpdated the About screen to report the correct app version.

Original release notes

NEW — a different fitting on each end of a spool

Spool Cut now takes a 90 on one end and a 45 on the other. One pass, one cut length. Each end's take-out is listed separately, with the source of the number beside it. Thanks to the fitter who wrote in and asked for this.

FIXED — accuracy

• Switching between Imperial and Metric now converts what you entered. Before, your numbers were re-read under the new unit, so a measurement could change meaning when you flipped the toggle.
• Deg ↔ mm/m reported the wrong slope in Metric.
• The Rolling Offset diagram labelled the hypotenuse "Travel". That side is the True Offset — Travel lies in another plane.
• Short Radius is offered only on sizes ASME B16.28 actually covers (NPS 1"–24"). Sizes outside the standard no longer show an SR take-out.
• Take-out now always states where the number came from: a tabulated ASME value, or a calculated approximation for angles the standard does not tabulate.

If you saved work in Metric before this update, it is worth checking it again.

IMPROVED

• Angle marks on the Miter Cut, Segment Elbow and Weld Prep drawings now show what they are measured from.
• Bolt numbers on the flange pattern are readable on every pressure class.
• The Saved list shows every calculator type, not just the offsets.
• The About screen reports the real app version.